Kdrweld's latest activity
-
KWe did the tape trick on another project recently, but with that deep pocket in the SXL even tape would have been rather challenging. Mark
-
KRebuilt a close ratio T-10 for my budget '72 Javelin endurance race project (24 Hours of Lemons). Now I need to build a backup trans.
-
KPoulan was an on line auction, never been fueled. The BP-1 was a FBMP that someone alerted me to, knew the fellow and we struck a...
-
KI just use a flat file
-
KKdrweld replied to the thread So what did you do today?.Like Billy says, get the gullet!
-
KI think im finally starting to get the hang of this.
-
KKdrweld replied to the thread Which 2 cycle oil ratio???.Or just run 32:1 the happy, medium for new engine or old engine technology. With a high-quality oil you can’t go wrong. If you’re in the...
-
KThank God we finally have another oil thread🙄
-
KI have a stihl 4 mix polesaw I use once or twice a year. I use the canned 4 stroke fuel mixed 32:1 with amsoil dominator. It can sit...
-
KSpent quite a bit of time chipping , scraping and wire-wheeling on this muffler. I'm convinced that for the last few tankfulls that this...
-
KThe 441 lives again :p It is heavier than I expected at 17.2#, PO I suppose I should replace that missing muffler hole cap, :p
-
KI had a bargain piston kit on hand, I don't remember now where it came from. Back together and running again. Mark
-
KA start:
-
KRan the 359 a bit tonight. She’s a dandy with a 20” 3/8. I’m getting a starter decal from my buddy on Friday, and the it will be for sale.
