Jusgunn3's latest activity
-
J261’s old will be an all new saw coming soon. Scott likes the mtronic himself better also from a performance standpoint anyway. From...
-
JUntil I’m forced into mtron/fi, only screw saws here. I figure when the 261 gen 3 comes out, won’t be able to get a standard carb.
-
JGreat saw except I’d want one without screws personally
-
JGo ahead and shut this one down, I present peak 50cc greatness.
-
JIn the case of 026/260, the intake is highly restrictive. Lots of other saws have a better intake so fooling with the details gains...
-
J260 not much difference over the 026 some are basically identical and others have 44.7 mm bore vs 44 after the epa regulations change...
-
JFlocked or winter mesh? If they’re pulling hard and choke spring is weak they will suck choke shut.
-
JGood point. You're talking about a different saw. In any case, what power gains do you expect to get with those minor modifications...
-
JAm I ever gonna get any royalties for starting the 543 love ? I tried to tell people they were good little units after being ported. Too...
-
JThis one's funny, same trans as the charger
-
JThat's ridiculous. May have but don't believe I've ever changed the filter on ours and it's pushing 300k, shifts like new.
-
JIirc first change I did on ours was 140k and it was a complete change. Still worked normally but was black as heck. Done a bunch of...
-
JJusgunn3 replied to the thread Chain Pitch and Gauge Identification.I have multiple brands and sizes and these are very helpful!
-
JNot a problem if you run just one chain, or one brand of chain, on one or two saws. But if you deal with different brands, with...
-
JYes. And there's no dipstick or drain plug. It's grounds for them to receive an F minus on their environmental score for making people...
