Jusgunn3's latest activity
-
JKeep sanding if the spot gets bigger it's junk if it cleans up more might be ok
-
JKeep going. Have to to remove ALL of the transfer. You're gonna be at it a while with 500 grit. After it's gone hit the bore with red...
-
JThat’s definitely aluminum. Either transfer still on the plating or no plating.
-
JSo I hit it with some 500 grit, I can definitely feel a low spot with my fingers here below, and also above, the exhaust port. Not sure...
-
JThanks, head is still spinning a bit.
-
JKit the carb, use a 372 intake clamp. New fuel line. Clean up the stock jug and get a meteor piston. I had a quad port 45mm hyway jug...
-
JOkay. I watched some videos, and other than the strap looks pretty straightforward. I'll tear it down this week and see what all parts...
-
JIf it wasn’t a Husqvarna, I’d say the plating is fine, but their plating isn’t always the best.
-
JThis might give you a few ideas.
-
JIt's possible that he might have loaned the saw out and someone else boogered it up. Looks like it might have been on of those where...
-
JYes, worth repairing! If you pull the cylinder off and check, you might be surprised, there might be minimal damage if any on the...
-
JYes. Those are good little saws. Some people put 346xp top ends on them.
-
JMy Grandpa came over this weekend gave me a husky 350 that is too much saw for his age. Said last time he went to use it he couldn't get...
-
JJusgunn3 replied to the thread The end of an icon......the final (2) 395 Husqvarna saws.I have one in a box I need to build one day…
-
JJusgunn3 reacted to Bill G's post in the thread The end of an icon......the final (2) 395 Husqvarna saws with
Like.
For a few years now have been hearing rumors that the 395 is going to be NLA in the USA................. I bought (4) new ones in...