JCMLAS0000's latest activity
-
Haters gonna hate. -
Same thing is happening on Facebook. About the only place where a new model isn't continually bashed is Youtube - there you just get...
-
This thread has gone the way of so many on the forums. This saw has not even been released to the states, ran by few across the pond and...
-
I have a mix of stock and ported saws in the fleet, more oil isn't a bad thing.
-
I hate proprietary bearings.
-
JCMLAS0000 reacted to legdelimber's post in the thread Cold weather-cold starting 550 xp autotune with
Like.
Does the heating element just feed strait from the source coil? When switched on. How many watts is the heat draw with a cold element... -
JCMLAS0000 reacted to Stump Shot's post in the thread Cold weather-cold starting 550 xp autotune with Like.
I think it's just the extra drag on the cold engine that is impeding starting, as the saw needs to hit 800 RPM to generate enough spark...
-
One thing I have noticed with the modern saws is difficulty diagnosing wiring problems. I’ve found bad wiring in 201, 462, 550 and...
-
Nicely and well put! Actual real life testimony based on facts and not just hear say!
-
There's been a lot of buzz going around about interest in the new 564XP saw with folks I talk to. Personally, I am excited to get inside...
-
And probably why I never had an issue with the very early 562 I owned. There are guys that can eff up an anvil.
-
JCMLAS0000 reacted to Maintenance Chief's post in the thread Husqvarna 564xp (g) fuel inject with Like.
This must be why the guys I cut with and myself don't have the bearing problems. We are chain sharpening fools!, but honestly once you...
-
As far as bearing failures go in the 562PXP(and 550XP) are concerned, bench analysis has attributed the retainer cage failures due to...
-
FWIW, I run Dominator at 32:1 in my fleet of saws, which see daily use logging hardwoods in the upper Midwest. They start easy, run...
-
Likely even better yet. It’s definitely cleaner than red armor. Just needs more of it to leave residual oil in the case