High Quality Chainsaw Bars Husqvarna Toys

Recent content by Jason628

  1. Jason628

    WANTED 038 mag p+c or just cylinder.

    Small end looks like it got a little hot...
  2. Jason628

    WANTED 038 mag p+c or just cylinder.

    Nice! This one's got the 52mm as well. I think my cylinder is fine. I took some measurements and skirt to cylinder clearance appears to be just under .002" so that's probably fine. No scoring remains and plating looks good. Just a few vertical dark lines left but, they ain't hurting anything.
  3. Jason628

    WANTED 038 mag p+c or just cylinder.

    I think my cylinder should be fine. Still a few vertical lines but, they're smooth. Followed the mmws guide to cleaning transfer off. Just hand sanded instead. Meteor piston is on the way. Going to try to get some good measurements with my hf micrometer and gage. Anyone know what is ball park...
  4. Jason628

    WANTED 038 mag p+c or just cylinder.

    Well... tank vent had the old style "grub screw" was not venting. Owner said it ran great until about half a tank and it acted like it was running out of gas. So I guess... running lean multiple times. Also had a screen type air filter and mass amounts of carbon build up. Scoring on both sides...
  5. Jason628

    WANTED 038 mag p+c or just cylinder.

    Finally got around to this thing. I think the aluminum transfer should clean off.
  6. Jason628

    Funny pic's and gifs 2021/2022/2023/2024

    Quitting my job.
  7. Jason628

    660 non sense.

    A few random problems with the clones I can deal with. I haven't had any catastrophic failures as of yet. The new neotec saw seems to be of better quality than the kit saws. Looking through the spark plug hole and the exhaust, the ports look more symmetrical and edges are beveled nicely on the...
  8. Jason628

    660 non sense.

    Cross cylinder is on.
  9. Jason628

    WANTED 038 mag p+c or just cylinder.

    I remember seeing that thread. I don't recall ever working on an 038 but, I don't imagine them being difficult to work on. It is a saw I wouldn't mind owning. My buddy just wants it fixed as a friend gifted him the saw shortly before passing away. I haven't seen very many magnum 2's around so I...
  10. Jason628

    WANTED 038 mag p+c or just cylinder.

    Sweet. Ya I'm not sure what the deal with it is yet. I don't exactly trust that shop. They were like well... It's going to cost $600 to fix it but, Come check out our new models over here! But, that's what he gets for taking it to the stihler... Supposedly it runs fine until it gets down to...
  11. Jason628

    WANTED 038 mag p+c or just cylinder.

    Curious if anyone possibly has an 038 magnum jug 52mm they would let go of. Buddy of mine took his saw into the shop and they said the top end is toast. Have yet to verify that it needs replaced but, it would be nice to have one found just in case.
Top