huskihl's latest activity
-
A little grinding and some black paint and it will look pretty good -
huskihl replied to the thread Preparing to port first saw - which one, and what method?.But to make certain we’re on the same page, blow down is the distance from when the exhaust opens to when the transfers open. It gets...
-
huskihl replied to the thread Preparing to port first saw - which one, and what method?.Not contradictory, just that I’m not relaying what I’m trying to say very well. Raising the transfers and raising the exhaust will both...
-
huskihl replied to the thread Show off your muffler mods.JacktheStitcher 😁
-
jackthepiper :D
-
Not pretty, but not exactly too ugly… zap zap zapped it around
-
huskihl replied to the thread Preparing to port first saw - which one, and what method?.A couple more degrees of blow down usually makes it a little bit more forgiving, but won’t hold RPMs as well in a simple down cut. You...
-
huskihl replied to the thread Preparing to port first saw - which one, and what method?.Run it without the air filter and see if it gets better. It could be plugged up, but I doubt it’s the actual air filter design. Only one...
-
huskihl replied to the thread Show off your muffler mods.Basically, the more outlet area you have, and the closer to being straight out, the more rpm and hp it will have. Torque on a dyno...
-
huskihl replied to the thread SOLD Makita 6401.Recoil and muffler say it’s a 6401.
-
huskihl replied to the thread SOLD Makita 6401.Just so folks know, Mike has trouble uploading pictures with his Internet. He sent them to me and I shared them here. He’s a good seller
-
huskihl replied to the thread SOLD Makita 6401.
-
-
-
https://opeforum.com/threads/ms500i-my-way.33065/
-
not quite sure what Im looking for underneath the flywheel, but it doesnt appear to be any obvious damage to the coil underneath, or the...
