hacskaroly's latest activity
-
hacskaroly reacted to Squareground3691's post in the thread MCCULLOCH The official McCulloch thread with
Like.
Stenciled bar -
hacskaroly replied to the thread MCCULLOCH The official McCulloch thread.Those look really good!!
-
hacskaroly reacted to Rallyeguy's post in the thread MCCULLOCH The official McCulloch thread with Like.
For those of you with the big iron... Just added larger stencils for 36" and larger McCulloch bars to my store...
-
Need some advice on troubleshooting a Stihl MS400c. The saw originally made it to me with low compression, piston in real bad shape...
-
Bought a Hyway x-torq cylinder and pop up piston and going to try porting it, anyone had success with this? My second option is to buy...
-
I would start by pulling the flywheel, cleaning the points again, and rechecking the gap. The spec's call for .020" but I target 0.018...
-
I completely finished the saw today. I primed it up, and it fired off for about 5 seconds and died. I couldn't get it to restart after...
-
Like this,,,
-
can some one provide me an old oregon one for revival?
-
Hopefully it's not running out from under the muffler
-
hacskaroly replied to the thread Husky 350 bar/chain oil leak.I forgot about that possibility, yeah, same thing here not much effort and the bar stud popped back into the tank. Whoever installed it...
-
Hope it’s not that but worth a check. Could be a bar stud came loose, I have had that before.
-
Oh interesting, my name over there is "Chainsaw Collectors"
-
The OP will be contacted by site Admin and a resolution should be reached.
-
hacskaroly reacted to jacktheripper's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
So, should I swap the ratty large clutch cover onto my 3/4 wrap 064, or keep the standard one on it?
