hacskaroly's latest activity
-
That is a very safe ratio. Keeps them alive for half a century! -
I look forward to seeing the videos. I’m a fan of modifying a stock muffler like a lot of guys here but I also love seeing new products...
-
372xp build for a friend...ground-up. Runs and cuts great. Blue, limited coil, tachs to 13+. But...comp is only 155. This was an...
-
242xp muffler... What were they thinking? 3 3/16" holes...that's it 😳 I had to cut off the entire deflector assembly to get this far...
-
hacskaroly replied to the thread Husqvarna 2100 thread.Holy crap, the last one I saw was $99 for an old worn out one. That's why I went with the UNI filter, it's whole setup was cheaper.
-
I guess it was finally cold enough and there was enough snow on the ground that the gas company decided it was a good time to run the...
-
I have three good covers. 2-61 and 1-266. Nothing broken. All have been cleaned. The 61 covers have the small diameter stem. One earlier...
-
I will take it Ernie, I fell in love with my neighbors PM700 while getting it running for him. Everyone could use another old hot rod...
-
The flat top is alive :D Runs and cuts like my old one...same motor but a RE... Scary fast with a 28, 8t, full comp. Oe topend, New...
-
Very excited about this. Just waiting on bearings to arrive.
-
Amazing what a good cleaning will do. In younger days I would crank up to half throttle. Now at 67, put my hearing aids in and tickle...
-
hacskaroly reacted to Roschdworschd's post in the thread bigger carburetor for chinese chainsaw / Komatsu Zenoah clone with
Like.
@Stefanseiner: If you whant....During the week I live in Freiburg, but at the weekends I'm in my home town....Humes. Wenn de wellschd... -
hacskaroly reacted to Leafy's post in the thread bigger carburetor for chinese chainsaw / Komatsu Zenoah clone with Like.
Wow somebody knocked me off. I don’t feel bad since they actually put effort in providing an already modified “firewall” and the carb.
-
hacskaroly reacted to Roschdworschd's post in the thread bigger carburetor for chinese chainsaw / Komatsu Zenoah clone with Like.
I know….long ago. But now i have found another solution. It works fine for me and it is possible to change it for any carb i whant.
-
I could have cut a port in the 261 muffler but they are a pain to open up and gut. I will post some before and after videos of both saw...
