hacskaroly's latest activity
-
I like your approach to this Greg. I know your a busier family man now. But, this site has needed some professional builder input for... -
I'll bet. That was a good catch and fix with seals you had on hand from other bearings. I've only used one aftermarket set of bearings...
-
Haha yup I deleted the video of it running but it was crazy the crank would shift every time you hit the gas
-
@Shane¹ I too am looking for some clarification on your mod. Did you add another seal over the integral bearing/rubber coated cup with...
-
Looks as if we were typing at the same time LOL.
-
Yup I used a 6203 bearing shield on each side and it takes up the slack. When I built the first one I pushed the bearings out all the...
-
Perfect timing for this thread to come up! Last cutting season my 350 developed an air leak. I shut it down and put on the shelf. I need...
-
hacskaroly replied to the thread Carpal Tunnel surgery?.I tweaked my back one time and it was a challenge to twist far enough to reach properly...sitting there looking around to see if there...
-
Unfortunately I am well acquainted with this issue. Some years back I had to have my right wrist fused and let's just say neither the...
-
If this clutters up Greg's build thread too much hopefully a mod can delete my post. But all of these builds are kinda his fault after I...
-
I would like this thread to be useful to folks down the road. That being said, I think this is a great addition. I'm sure other folks...
-
How about tank vents falling off? I worked on several earlier this year where the white vent fitting wouldn’t stay in the tank and I...
-
You can post up what you found. I do need to touch on tank vent modifications at some point in this thread for saws with the EPA vent...
-
This is what it looks like when the vent is missing. This is on a saw with a primer (I can’t remember if all the 350’s have primers)...
-
hacskaroly replied to the thread Husqvarna 350 build thread.Sorry, I am not sure if I am picking up what you are putting down...did you make a spacer from an old oil seal to take up the slack...
