hacskaroly's latest activity
-
Thanks for the bump. Erie, Cool old saw! Good luck. -
Have you altered the intake duration? Do you get spitback out the carb?
-
No spitback, two of the saws were very much altered, but professionally by @drf256 and @Mastermind and the issues go away with different...
-
It is winter time and im surprised nobody hasn't mentioned the issues that come from cold weather ops. All Carburetors like warm air...
-
Checked with a couple dealers and found one that had a WT-426B carburetor for $80 It doesn’t have the limiter tab on the high jet. But...
-
Oh, I have a small pile of those, I think only one left with the stock dished piston. A couple of them are now 346s. Some of these are...
-
There is definitely value in taking some time to modify the stock 350 for a low-buck rig. If you have run a good ported 346xp, you can...
-
Problem with the one I have that does this is that the tune that holds idle when you pick it up doesn't accelerate well and the tune...
-
That is actually what I have been doing on a couple of saws in order to pick them up. The blips do work, and you can tell that it’s...
-
I have a theory, because the carburetor is set so lean at idle, the throttle plate is therefor closed too tight/much to compensate for...
-
hacskaroly replied to the thread Carburetor talk - fuel puddling.Just out of curiosity, I wonder if there is any difference if you blip the trigger a couple of times before picking it up, if it would...
-
I've experienced the same thing but it's caused by vibration.. Putting the saw on the ground it vibrate the carb and would idle richer...
-
Interesting question...and from the sounds of it, I'm not going to say anything that you don't already know/haven't tried. Letting a...
-
I have been dealing with several similar issues on a few different saws lately. The issue is definitely related to the carburetor on...
-
Around seven years ago I did a 350 build with no timing changes. I got rid of restriction in the cylinder riser, smoothed all of the...
