hacskaroly's latest activity
-
hacskaroly reacted to nv656's post in the thread WANTED Husqvarna 2100/1100/2101 Pro safety HD wrap handle with
Like.
I have a nos pro safety with the rubber but they supposedly also made the “HD” which is the one pictured and kicks the saw up higher to... -
hacskaroly replied to the thread WANTED Husqvarna 2100/1100/2101 Pro safety HD wrap handle.That would be awesome if they did, my 2100's front handle has been around the block a few times and I don't want to pay $100+ for...
-
Generally speaking you can't hone out ovality or taper on a plated cylinder .Transfer you can remove but use something like 3M "Scotch...
-
hacskaroly reacted to Woodslasher's post in the thread WANTED Husqvarna 2100/1100/2101 Pro safety HD wrap handle with Like.
Just an fyi, that's a Husqvarna 1100 wrap handle in the picture. Also, the Pro Safety version came with a rubber wrap just the like...
-
I have an 038 magnum that I have torn down to put new rings in. I was wondering what everyone recommends to use for honing? I typically...
-
hacskaroly replied to the thread 038 magnum.I have used the brake hones on cylinders and have gotten good results from it, but made sure to have plenty of oil and use it in short...
-
hacskaroly reacted to IffykidMn's post in the thread Looking at upgrading and would welcome advice/opinions. with Like.
Have several standard carb 261s run a 16" B&C and have no complaints for a 50cc saw, I tend to run short for cc bar and chains. Good...
-
hacskaroly reacted to old saw fixer's post in the thread Looking at upgrading and would welcome advice/opinions. with Like.
I use Stihl and Echo power equipment, but lately have bought Echo. I have a Stihl 261CM and would recommend it to you. The Mtronic...
-
hacskaroly reacted to tallgrass_coyote's post in the thread Looking at upgrading and would welcome advice/opinions. with Like.
Had a seasonal job after college working for the state wildlife agency. Main job was to kill trees (girdle+tordon). My boss bought a...
-
hacskaroly replied to the thread Looking at upgrading and would welcome advice/opinions..The 261 is a great saw with its power to weight ratio. Carb vs. C-M ends up being personal preference, if you like to adjust carbs (or...
-
hacskaroly reacted to edju1958's post in the thread MCCULLOCH The official McCulloch thread with
Wow.
I took a look at this crank & piston,& the piston is pretty well shot - it's got some deep scoring to it.You might say "change the... -
hacskaroly reacted to Scott Kelsey's post in the thread MCCULLOCH The official McCulloch thread with Like.
Mark, thank you very much. This is extremely helpful. I will read your link this evening.
-
hacskaroly reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Scott - I don't know if I tried to put together a similar thread here on OPE Forum, but there is a pretty complete thread on the Walbro/...
-
hacskaroly reacted to Scott Kelsey's post in the thread MCCULLOCH The official McCulloch thread with Like.
Wondering what you guys can tell me about this 797 carburetor. I believe it is a Mcculloch flatback? From old threads I have read...
-
hacskaroly reacted to nv656's post in the thread WANTED Husqvarna 2100/1100/2101 Pro safety HD wrap handle with Like.
Looking for the large oversize Full wrap handle for a Husqvarna 2100/2101. in best shape possible or NOS Similar to this