fossil's latest activity
-
A couple of boxes from California arrived this week, with so much going on here I didn't even have a chance to peek inside yet. Mark -
-
fossil reacted to heimannm's post in the thread SOLD Mcculloch technical service library manual with
Like.
I am missing the earliest service bulletins and some IPL's here and there, but I have a pretty large selection of McCulloch documents on... -
fossil replied to the thread POULAN The Official Poulan Thread.I made a few sockets that work well on clutches. Take an old or cheap socket and cut down on them with a hack saw and break the piesces...
-
-
fossil replied to the thread POULAN The Official Poulan Thread.The proper "O" rings for the fuel and oil caps measure 1/8" thick with an ID of 1-1/16" . Make sure they are nitrile (BUNA N) To split...
-
fossil replied to the thread POULAN The Official Poulan Thread.Squirt some mix in the spark pug hole and see if it will start. That will get some lube in there. Some saws sitting for a long time...
-
fossil reacted to woodfarmer's post in the thread The forestry and logging pictures thread with Like.
just able to sneak it past the young beech, couple nice maple too
-
fossil reacted to woodfarmer's post in the thread The forestry and logging pictures thread with Like.
So last of logging ‘26. Above zero here now and the rain is to come later this week.
-
I was thinking about getting some spinners for my saws, maybe a lift kit.... 🤣
-
...on his trailer again?
-
fossil replied to the thread Walbro sdc 37a.I see you have an SDC 37, not an HDC carb. Here's a file that lists all of the part numbers you need. Scroll to the SDC 37 and refer to...
-
fossil replied to the thread Walbro sdc 37a.
-
-
fossil reacted to old_sir_henry's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
New in my collection: DOLMAR PS-401 built 1996, never used, never assembled and never fuelled, with original box and accessories.
-
Looks like a 1200B...made by Reed-Prentice...
-
I haven't managed to get the SP81 into any wood yet but it still starts and runs reliably for the few minutes I manage these days...
![clutch_sockets[1].jpg](/data/attachments/484/484934-0407329f4360254f1f906dbd3165ba61.jpg?hash=ZYjvNiZ2Y2)
