ferris's latest activity
-
My brother has one, it is stock, and he loves it. My ported 261 is my favorite small saw (with 18" 3/8). -
Howdy fellas, been a while. Been busy too, which is a good thing!
-
But don't worry. 400.1 is much simpler:))
-
This is how I did many of them without a problem.
-
ferris replied to the thread The Stihl MS241 Thread.I know an old thread, but I want to share some information. I love the small saw for small felling and limbing jobs. Since new i was...
-
ferris reacted to Loggernate's post in the thread The forestry and logging pictures thread with
Like.
-
Thank you Kev. I will show pictures of it relieved as I go forward. Time has been the biggest hindrance for me. Hoping to get final...
-
Tiny pointed and/or flat burs. It’s not crazy important to have it perfect, it just can’t be high. I try to make certain I’m at least...
-
Can’t. The lathe stays outside of it
-
My post was different than what they were talking about previously. Those arches that Al probably cut deeper are to make room for the...
-
Doc, the cylinder extension won’t fit all the way down in after you machine the base without removing this area on each side where the...
-
Not to disparage any individual rather people in general including myself, I find that 9 times out of ten that the last place something...
-
Metering gasket and diaphragm orientation inverted, or improper metering lever height would be possible culprits.
-
Okay so i cleaned the carb and installed new gaskets and diaphragms and installed a new air filter. The carb had an air leak which has...
-
@drf256 Did you enlarge the curved cutouts at the bottom of the cylinder walls? I’m not sure that I understand what their function is.