FergusonTO35's latest activity
-
FergusonTO35 replied to the thread Gun range 2022,2023,2024,2025.That looks like the case body has been shortened as well as necked down? -
I smoke 99% of the time outside. My Grandfather rarely smoked cigars but smoked a pipe from the minute he rose before dawn and until he...
-
FergusonTO35 reacted to KS Plainsman's post in the thread Pipers sound off if you’re present with
Like.
Been a bit since this thread has had a bump. I'm smoking some Sutliff 507S Stoved Virginia, in my first Country Gentleman pipe. It... -
FergusonTO35 replied to the thread ECHO Echo, Echo, Echo.The only thing I could find was a bit of oily sawdust accumulation inside the clutch drum. I could hear something inside there grabbing...
-
Was anything wrapped around outside of the crankshaft? Was the oiler gear stiff on the crank? I don’t know that I’ve ever seen anything...
-
FergusonTO35 replied to the thread ECHO Echo, Echo, Echo.Ok guys, the clutch is catching at idle (3200 RPM) on my 500P but I can't figure out why. Any ideas here? This saw doesn't have many...
-
-
FergusonTO35 reacted to edju1958's post in the thread MCCULLOCH The official McCulloch thread with Like.
I finished up on my latest PM 10-10 today.I went to take the old fuel line off the carb & it broke in half just by putting a pliers on...
-
FergusonTO35 reacted to Maintenance Chief's post in the thread POULAN The Official Poulan Thread with Like.
Rescued from the scrap yard a few years ago. Seems to have had an easy life. It needed fuel system refresh and crank seals...
-
FergusonTO35 reacted to heimannm's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
Hard to pull over at age 40 is much different than hard to pull over at age 70...
-
FergusonTO35 reacted to mainer_in_ak's post in the thread HELP! Help with first time porting Echo 800P with Like.
I never changed the upper transfers on mine and love the way it runs with 28" and 36" bars in bar-length wood, using LGX, EXL and Xcut...
-
FergusonTO35 replied to the thread Saw rebuild and/or porting. Apply within.I did a lot of cutting with the ported CS-500P today, this is one fun saw to run. Also, after adjusting the carb up down and sideways...
-
-
-
FergusonTO35 reacted to farminkarman's post in the thread HELP! Help with first time porting Echo 800P with Like.
I've never ported a cs800p, so I don't have any specific info to share. I can make some suggestions though. For starting out, don't...
-
FergusonTO35 reacted to dthieme's post in the thread HELP! Help with first time porting Echo 800P with Like.
Awesome, thanks for the tip!
-
FergusonTO35 replied to the thread HUSQVARNA HUSQVARNA THREAD.If you are willing to consider another brand, my Echo CS-500P really woke up after Kris at S&S worked his magic on it.
