Recent content by Evan03

The 461 has become my favorite. Ive spent some time with temp gun tunning length. With it to long it made good top end but lathargic on the bottom. Pipe as pictured picked up quite alot of low grunt. only have but dyno to go off of.. Saw is mainly stock with a pop up piston and stock ports...

Shes cut some. Did a pipe for it. This saw is a beast in the wood. Havent ran the pipe yet

Any power increase with the extension? I think it will run for about 3 seconds under water maybe slightly longer than a urban snorkel on a Toyota

Got the 44 muffler buttoned up. Will do some firewood cutting in the next few days to see how it goes.

I think it all matters in the world of harmonic 2 stroke exhaust tuning. Id, wall thickness, length, straight, curved, chamber, no chamber, Ive slightly eyed doing another pipe staying away from muffer bolt and making a full circle I think I can with slight tighter shorter pie cuts. By Short I...

What saw. Yes you could do insert with a set screw or weld a nut so you can jamb riser tight

372 has been doing quite abit of cutting so ive fekt I needed to get the dang 44 project going. 44/064 ended up being a flop. Shes up as a 46 and running well, alittle ported and alittle bit tight squished with gasket. Pulls pretty good for alittle saw. Been playing with different...

I was gona ask the same?

No its just a pipe. Just playing with different ideas

Damn wish you had free wood in idaho Sent from my SM-G781U using Tapatalk

Sunday Sent from my SM-G781U using Tapatalk

Vid from the weekend. https://youtube.com/shorts/CGXjYm0vMB4?feature=share https://youtube.com/shorts/pECn31a8FUU?feature=share Sent from my SM-G781U using Tapatalk