Recent content by erikb

Here's the pic's. The bearing wasn't pressed in after all. The grease was holding it in. Looks like it fits a 9/16 crankshaft. (.562) Erik.

I have one with original number 4304 on the box. It has N116-A7 stamped on the drum. Time to take some measurements. Can you send your I.d. O.D. shaft size ? This one has the bearing pressed into it. I'll send pic's tonight , with sizes.

I'll check the boxes in the morning.

If you know the part number, let me know. I have a bunch of mystery clutch drums. Erik.

Ok, thanks .

PM'D you.

I'll take the McCulloch parts if they are still available . Will they fit in a USPS flat rate box ? I have paypal. Erik Belter 1242 Magnolia ave. Petaluma, Ca. 94952 Thank you calls are best during the day 707 762-3249

over 100 : 4 (bit of a hoarding problem)

https://www.leonschainsawpartsandrepair.com/repair--tip-videos.html#/

You said the valves are moving, did you check the clearance ? If they are too tight it will give the low compression reading. .004" on both valves is ok.

I am also interested in a husky 55 open port piston if one is available. $? Erik.

Payment sent. Shipping address should be on it. Thank you ! Erik.

I dm'd you. Erik.

Hi Scott, How much to ship the 25" parts to 94952, Calif. Thanks. Erik

good stuff- thank you.