High Quality Chainsaw Bars Husqvarna Toys Hockfire Saws

emanuel's latest activity

  • E
    emanuel reacted to SawNut's post in the thread 881 vs 661 with Like Like.
    What do you like better about it, aside from cost and oiling? The price on the 881 has gotten insane. I'm between the two myself right...
  • E
    emanuel replied to the thread Bigger setup for CS milling.
    No issues oiling the 48, but I’m planing to get a 72” soon. I’ve seen that oiler from australia, $200 no thanks 🤣, you need a dripper...
  • E
    emanuel reacted to SawNut's post in the thread Bigger setup for CS milling with Like Like.
    Thanks for the info on bar/chain size, and on the dual saw setup. I do also see that there is a high output oiler for the 881, but...
  • E
    emanuel replied to the thread Bigger setup for CS milling.
    Keep the .404 with these large bars and saws, it handles the load substantially better than 3/8, less stretching, less sharpening, for...
  • E
    emanuel replied to the thread 592xp coil replacement.
    Only husky autotune coil I replaced was an 2018 made 572xp which ran after that. I have no idea if their latest autotune iteration is...
  • E
    emanuel replied to the thread 592xp coil replacement.
    There’s no way this is real, it would be a massive minus for Husqvarna… For Stihl mtronic or fuel injection any part can be changed...
  • E
    emanuel reacted to atimmons101's post in the thread 881 vs 661 with Like Like.
    For sure. I think for bucking huge hardwood and stumping as well as milling. I just think the 500 and 661 are fairly close but the 881...
Show older items
Top