EFSM's latest activity
-
EHusqvarna 55 Rancher. Runs great. Very good condition. New fuel line, filter, air filter, spark plug, carb kit, sprocket, oil cap, pull...
-
EI'm not looking for trouble. I've been reading OPE posts for a couple years and have seen how fragile issues can be. I'll play by the...
-
EI think as far as your saw is concerned, if it runs good you are done. It will still work as it should I think. I’d seek out help if it...
-
EI wouldent worry so mutch. Just run it for a day, then check if it still slacking. Usually the problem Will disapere.
-
EEFSM replied to the thread Broken piston crown (Echo CS-7310p).I’ll measure the gap later this week.
-
EEFSM reacted to Only the Tony's post in the thread how about a Oklahoma,AR,MO,KS,TX,+IA GTG thread? with
Like.
Had a visitor show up in the yard today. Usually see them in the trees out in the field when they come into the area. And now I am... -
EWell, look at that....
-
E"I have a feeling there will be issues with the bearings in this series." Does 560 - 562 mkII - 564 still have revboost ?
-
EThis saw continues to impress me. I can only say good things about it so far. There are some little nuances but overall it is a really...
-
EYou are correct. I had one but it must be out of calibration as the last saw I used it on was set for specs and snapped one off so I...
-
EThat 6 inch~ish travel per change, kinda tilts me towards the nose sprocket. Figure a smidge more than three times (3.1416...) the...
-
EEFSM replied to the thread Broken piston crown (Echo CS-7310p).There is no scoring, which should happen during a case of the ring being tight. Also, a tight ring gap would show up before a year of...
-
EIt is sad that farm toy shows have all but become a thing of the past.
-
EEFSM replied to the thread So what did you do today?.My paternal grandparents live 8 miles north of Wenger’s.
-
EYesterday I took a little road trip to Wenger's Equipment in Myerstown to pick up a 6ft JD scraper blade for $400 20 mins later I...
