EFSM's latest activity
-
EAustralian Axemen hall of fame Libby Prescott. Bob Radford 1920 s pegging a tree. Cutting the head Big timber in the hills above...
-
EEFSM replied to the thread HELP! Ht133 pole saw.I’ve worked on quite a few Stihl pole saws over the years, but mostly 130’s and 131’s. I pretty much have to relearn each time, because...
-
EMS441C Magnum PHO for sale. I would sell the 25” bar and new chain for an extra $25 but it would cost quite a bit more in shipping...
-
EHere’s some more
-
EAnd a couple more
-
EThis Remington SL11 was pumping a lot of air and very little oil. The pickup in the tank was pretty plugged and the line from the oil...
-
EEFSM replied to the thread What's on your bench?.By top passages you mean the mix needle passages? Usually corrosion doesn’t affect them as much because they aren’t sealed like the pump...
-
EEFSM replied to the thread What's on your bench?.Whether to save it or not depends on how rare the carburetor is. Hitting that with a sandblaster and polishing the face would bring it...
-
EPhilbert
-
EEFSM replied to the thread So what did you do today?.Nah, probably just keeping after it better.
-
EEFSM replied to the thread So what did you do today?.Yesterday I was trying to reclaim a fence that was being overtaken by multiflora rose bushes and various other brambles/bushes. It had...
-
-
ERan these four today. The 61, 041, and 031 are running like champs. The 450 was running good, but now it decided not to oil. I’ll have...
-
ETiny pointed and/or flat burs. It’s not crazy important to have it perfect, it just can’t be high. I try to make certain I’m at least...
-
EI tried putting a couple of those jackdonkeys on ignore, but then just put the whole Political section on ignore. It's a much more...
-
EEFSM replied to the thread 400 CM Build.Makes complete sense now. I hadn’t seen the flat spots until now.
