Duane(Pa)'s latest activity
-
Duane(Pa) replied to the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets.This is what he’s talking about -
Duane(Pa) reacted to Chris H's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with
Like.
I should have mentioned this is the T&S square grinder that I bought. -
Duane(Pa) reacted to Chris H's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with Like.
I just bought this grinder and got it last week. I have wanted a square grinder for almost 40 years. I had always wanted a silvey or...
-
I prefer to restore the depth gauges to factory profile, to minimize the risk of a sharp corner catching. Use a flat file, Dremel, or...
-
Flat but angled. Lower in the front. The lower you go the steeper the angle.
-
Duane(Pa) reacted to cuinrearview's post in the thread SELLING Sugi Hara Lightweight Bar KO95 3/8"x 18" x .050 x 68dl with Like.
I have one of these on my ported red 346. Feels like the perfect fit and balance. With an eight pin rim it's a hell of a firewood...
-
Duane(Pa) replied to the thread Raker shape.So, I suppose you end up with a flat top raker? If that works, then we are sorta answering the question.
-
They are an excellent gauge. If you don't have a good memory best keep the little diagramed card handy that shows which slot is what...
-
Get a progressive raker gauge. The WCS is the best I’ve seen. It gives you depth options. A simple jig that sets the raker for the...
-
Duane(Pa) replied to the thread SELLING Sugi Hara Lightweight Bar KO95 3/8"x 18" x .050 x 68dl.Make an offer and BUMP
-
Nice 026, looks familiar 😎
-
Duane(Pa) replied to the thread Raker shape.I have never been able to tell any difference from behind the saw. My smoothest cutting chains are the ones with the most consistent...
-
I’m not sure which one I have but it’s been solid. Will buy more in the future.
-
Anyone got any long term run time on the blue label? Thinking about another 3 pack of 20”. No issues with the orange. Duke says there...
-
Does anyone have any suggestions for the above post ? I think I may order a rebuild kit today and give that a shot . The old components...