Duane(Pa)'s latest activity
-
Duane(Pa) replied to the thread Chain Technical Information.This is a very cool thread. Thanks! -
Spent quite a bit of time chipping , scraping and wire-wheeling on this muffler. I'm convinced that for the last few tankfulls that this...
-
Duane(Pa) replied to the thread Wiseco Pistons from CCC Racing.
-
-
Duane(Pa) replied to the thread Old Homelite project 🤔.He is a fountain of knowledge. Some of the vids of him actually wrenching have left me a little woozee! Once he gets flustrated...
-
I'm pretty happy with the results . Adjuster block slides smoothly throughout its travel fore & aft . Epoxy seems very strong 👍.
-
When in doubt Moto seal is your friend. It is great for any gasket delete or any unsure gaskets. This is not the space shuttle that we...
-
Piston came out pretty nice . No scoring but I scraped a ton of carbon off . Lands were loaded .
-
Does anyone have any tricks to install the 28 tiny rollers in the lower connecting rod ? My plan was to put a coating of synthetic...
-
I think I'm pretty good at spinning wrenches and everyone pizzes & moans about how difficult McCullough saws are to work on but honestly...
-
I made up a flywheel puller from some old stock I had lying around and it worked perfectly . 3 sharp raps after snugging the screws and...
-
Husqvarna saw # 3 all oem 300 shipped lower 48 I will be listing a bunch of saws over the course of the next few weeks so here it goes...
-
Husqvarna 254 anniversary sticker 225 shipped saw # 5 I will be listing a bunch of saws over the course of the next few weeks so here...
-
Looking for a minty NE346 preferably XPG but XP is fine.
-
Duane(Pa) replied to the thread RIP Saw 500i.I wish I was savvy enough to put a gif of Trump saying “THEY DON’T KNOW WHAT THE FUKC THEY ARE DOING” re RipSaw but alas I am mired down...
-
I’ve done about 170 for a dealer in Ohio and 150 more outside of that. Couple different recipes depending on what they want, but the...
