David Young's latest activity
-
Here’s the victim, fresh outta the box -
David Young reacted to dangerousatom's post in the thread 550xp port job is running weird on 1st start….. help with
Like.
Excellent! I am thoroughly impressed with the power with only 5-6 tanks of gas through it. Cut some big dead ash a few weeks ago and... -
David Young reacted to farminkarman's post in the thread Post up your ported cylinder Artwork with Like.
346xp 42mm
-
Still playing with 50cc stuffs...
-
Tree95 for a local dood.
-
David Young replied to the thread Pistons to cylinder.if a saw is well taken care of the cylinder will show little wear after many hours of use. However I think people try to use a piston...
-
Bikes routinely get multiple pistons per cylinder, but with them the limiting factor is the dirt they ingest. Chainsaws don't have to...
-
David Young replied to the thread 230psi in a Poulan (42cc, wild thing, etc)!.what saw was this. did you test compression after you ran it? did it run ok what is the exhaust port at?
-
David Young replied to the thread How i can build race pipe.Anything can be a race pipe if you are dumb enough or drink the the crayon water koolaid
-
Here's the 288 and 61
-
David Young replied to the thread Purchased a bunch of Huskies.Crips I’d just be happy having friends. 😕
-
The other day I purchased a bunch of Huskies from a buddy... (2) 335xpts, 340, 346xp, 440, 455, 61, 288Xp, K760 demo saw and a 550xp...
-
Bearing same. The MS360 drum is actually deeper than the 1128 drum. Using an 1128 drum will cause the oiler gear to not engage unless...
-
David Young reacted to ajschainsaws's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
Had this from eBay a few weeks ago buyer said it pulls over but won't start and couldn't see exactly which model it was from the poor...
-