dangerousatom's latest activity
-
dangerousatom replied to the thread HELP! 372 xtorq issues.-If you have another of the same saw start swapping parts one at a time, carb, coil, flywheel, ect until you find the culprit. -Could... -
dangerousatom replied to the thread Husqvarna 572xp in 2026.I must agree with everyone so far the 572 & 565 are both great saws. They run extremely well stock & with a heavy muffler porting and...
-
dangerousatom replied to the thread Chain changing tension as it rotates.^^^ I’d have to agree if it’s not the chain it’s the gear on the bar tip. Clamp the bar in a vice with a square along side and leave a...
-
dangerousatom replied to the thread Chain changing tension as it rotates.. Ya I asked that few days ago….?!?
-
dangerousatom replied to the thread Chain changing tension as it rotates.LoL maybe 🤔 I’m not laughing at ur comment but how we are all spit-balling this. Have you swapped out the chain yet? That’s were I’d...
-
dangerousatom replied to the thread Chain changing tension as it rotates.My money is on a tight bunch of rivets or sloppy holes on the chain. A bearing, rim sprocket or nose sprocket will not give that much...
-
dangerousatom replied to the thread Husqvarna 550 xpg hood latch.Sell them on amazon for 5 for $8.50ish They may not be OEM but they are cheap and you can store one of 2 inside the saw cover back by...
-
dangerousatom replied to the thread Husqvarna 562 MK2 beginner porting.Not too terrible for 1st time.... Pull the transfer covers off, there's a few ruff bits in there and it lets you get to the lower...
-
dangerousatom replied to the thread Echo 2511T fuel tank repair.Ok here’s the long explanation: I could not recommend any epoxy, as plastic fuel tanks and cans are a type of plastic that is...
-
dangerousatom replied to the thread Echo 2511T fuel tank repair.Don’t know. If you have some sitting around test it out on the outside, really nothing to loose?!?
-
dangerousatom replied to the thread Echo 2511T fuel tank repair.Any epoxy that is fuel safe, but a tank sealer epoxy is best...the kind you put in a tank that has a leak/hole and roll the tank around...
-
Thanks for the replies. I'd considered the superglue fix and melting the plastic. I wasn't sure of the techniques. I'll combine the...
-
dangerousatom replied to the thread Echo 2511T fuel tank repair.Super glue it shut clean off any excess glue when dry and then get the same plastic to drip seal/patch it. What this is, is basically...
-
dangerousatom replied to the thread So what did you do today?.Played with the new $74 shoebox size, amazon flux core welder. Very surprised at what it could do without any wire speed control...
-
While “working” today I grabbed two of the icon magnetic mats from Harbor Freight. I thought the magnets would be stronger but it works...
