cuinrearview's latest activity
-
cuinrearview replied to the thread Walk over to your toolbox right now….What's a fella gotta do to get a new CCC t-shirt around here? Mine is a couple washes away from being dust in the wind. -
-
cuinrearview replied to the thread HELP! 372 xtorq issues.
-
-
Just a random spitball. Walker's posted a vid about it not too long ago 'erratic running and idle problems due to pooling'. My 2015...
-
cuinrearview replied to the thread HELP! 372 xtorq issues.I thought he said a new carb fixed the two that had sat and were running poorly. I may have missed it though, that was a lot.
-
So in the end, it idles erratically? What color is the coil?
-
Send Shane a 6100 without a coil but otherwise functional and He will tinker up a coil to fit! :thumbsup:
-
cuinrearview replied to the thread Not so pros 4 new and without politics or drama.Gettin' mighty ghey up in here
-
-
On the way
-
Are you saying tank holds pressure? Why, that tank is open to air though vent.
-
Clutch side O-ring? Pressure/vac fuel line? Obstructed pulse? Bad wires? Oiler bolts? Cracked case or jug? Freeporting piston...
-
cuinrearview replied to the thread HELP! 372 xtorq issues.For the tl/dr crowd: carburetors gum up when they sit, and he needs help assembling a case. I see nothing "x-torq" specific here.
-
cuinrearview replied to the thread Not so pros 4 new and without politics or drama.Apparently, if you cut firewood in a national forest, you now have to pay for a permit to do so.
-
cuinrearview reacted to Duane(Pa)'s post in the thread SELLING Sugi Hara Lightweight Bar KO95 3/8"x 18" x .050 x 68dl with
Like.
Make an offer and BUMP -
cuinrearview replied to the thread SELLING Sugi Hara Lightweight Bar KO95 3/8"x 18" x .050 x 68dl.I have one of these on my ported red 346. Feels like the perfect fit and balance. With an eight pin rim it's a hell of a firewood...
-
I'm going to lock this for now pending further information from Dave.
