Creaky limb tree care's latest activity
-
CI really like those caps. Or like Echo so you can use the starter handle to loosen them.
-
CCreaky limb tree care reacted to huskihl's post in the thread Flippy gas cap leaking....... with
Like.
Look into the all black non-flippy flippy caps like David said. I believe proline is the only supplier now. I still have a few from when... -
CCreaky limb tree care reacted to DillonBuck's post in the thread Flippy gas cap leaking....... with Like.
Or do as Husky did. A screw flippy cap. The flippy provides the leverage to loosen a tight cap. As long as the gorilla is shark enough...
-
CCreaky limb tree care reacted to IffykidMn's post in the thread Flippy gas cap leaking....... with Like.
But you are missing the upside of flippy caps no need for a scrench. :meparto: Perhaps someone could design a scrench with built in...
-
CCreaky limb tree care reacted to Lawless's post in the thread Flippy gas cap leaking....... with Like.
Look at it close when you close the flipper. If you see the cap body raise up on one side it is trashed and plastic is broken.
-
CCreaky limb tree care reacted to MtnHaul's post in the thread Flippy gas cap leaking....... with Like.
Yup. The oil tank cap on my 028S still has the original cap and chain. The flippy cap has resulted in more spilled bar oil for me than...
-
CCreaky limb tree care reacted to Mad Professor's post in the thread Flippy gas cap leaking....... with Like.
Stihl took two steps backwards with flippy caps. The best caps are on the old saws that had the metal chains and hook that kept the cap...
-
CThe o-rings are never tight. Look at the outer part of the o-ring where it seals against the taper of the tank. If there is a flat spot...
-
Csome fine looking work as always
-
CThis forum is loaded with knowlegeable fellas willing to help:cool:
-
CDoc, the cylinder extension won’t fit all the way down in after you machine the base without removing this area on each side where the...
-
CCreaky limb tree care reacted to redneckhillbilly's post in the thread Carburetor talk - fuel puddling with Like.
this reminds me of the gadgetman groove, esentially a groove on the housing around the part of the throttle plate that opens, supposedly...
-
CCreaky limb tree care reacted to jacktheripper's post in the thread Carburetor talk - fuel puddling with Like.
My theory is now that turning the idle up cracks open the throttle plate enough at the bottom of the carb body to allow air to sweep any...
-
CCreaky limb tree care reacted to jacktheripper's post in the thread Carburetor talk - fuel puddling with Like.
I minorly opened up the throttle plate bypass notch last night in the hd14 on my 044. Today I tested it and it was better, but not...
-
CCreaky limb tree care reacted to jacob j.'s post in the thread Carburetor talk - fuel puddling with Like.
Years ago (mid 1990's) I had an 026 that was having issues at idle - a local long-time small engine tech told me to notch the throttle...