First up 395xp
Mike built this one up for me a few years ago it’s oem piston and cylinder wasn’t seized up before the rebuild. it’s been hardly used since has a full wrap bar and currently a 404 sprocket on. Operator lever could be replaced, comes with what ever spare parts I’ve got couple...
Less than 10 tanks bucking some firewood on this one, full wrap bar. Story here is I got this one sent up from Randy last spring plans changed and now told we gotta move from our rental so..
1300USD + I’ll split shipping from Canada
Paypal ff or add the fees.
Not sure on what the 390’s are...
Time to offload another one..
This one’s been sitting on a shelf at work for years tank/ handle busted probably from when they were using a Lewis winch on it. Could do a deal with the old winch also.
Fires up runs idles etc I think I pulled the muffler off years ago and it was good but can...
Case halves
3pto reds in best shape I orange has good top screw but a dawg bolt snapped in there..
1flywheel side- top screws need repair
2x385 cylinders might clean up
2x385 pistons could probably use ‘em.
2x 385 caber rings
1 carb base plate
1 red carb base plate - if your into that…
1...
Next on the spring clean
Saws a 181 bottom with 288 top end ran after the swap now think the fuel lines bad?
Extras
181 top end that was removed in good shape
2 wraps handles and a half I believe if for them
Low top and high top cover
Extra high top filter elbow
Starter cover works/pto cover...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.