brushwacker's latest activity
-
BEasiest way I would think is to run a few tanks of quality non ethanol fuel with Red Armor. There are quite a number of folks that have...
-
Bbrushwacker replied to the thread SELLING GB BARS and TOTAL SPROCKETS.It's difficult for me to focus on most the labeling. Very interested in 3/8 picco bars that fit small Stihl 017 to ms250. 050 gauge...
-
Bbrushwacker replied to the thread SELLING Husqvarna 55 Rancher parts or project.Bump
-
BGot this 7310 as a project saw. Plastics are pretty faded but a solid saw. Rebuilt and put back together new bearings, seals, caber...
-
BGot this 7310 as a project saw. Got it rebuilt and put back together nicely. New bearings, seals, caber ring, oil gear etc. Runs and...
-
Bbrushwacker reacted to EFSM's post in the thread Cold weather-cold starting 550 xp autotune with
Like.
It could be a bad coil. I’ve seen a bad coil on a 550 (2022ish) that was totally random and very frustrating to diagnose. -
Bbrushwacker reacted to FederalQ's post in the thread Cold weather-cold starting 550 xp autotune with Like.
I would not believe the heat switch would make a difference to the spark plug, it’s a separate system. I have the same issues with a...
-
Bbrushwacker reacted to DillonBuck's post in the thread Cold weather-cold starting 550 xp autotune with Like.
how old is your gas? If there is any chance it was summer blend, get fresh. The ability to evaporate in cold temp is the basic...
-
Bbrushwacker reacted to redneckhillbilly's post in the thread Cold weather-cold starting 550 xp autotune with Like.
I think these autotune saws take more a healthy pull to get them to fire up, if you have a bad shoulder and cant give it a healthy...
-
Bbrushwacker replied to the thread Cold weather-cold starting 550 xp autotune.I get a good pull drop starting with my left hand on the pull cord until about 10 pulls i begin wearing down. Been using an 064 when...
-
Bbrushwacker posted the thread Cold weather-cold starting 550 xp autotune in Husqvarna AutoTune Saws.The other day at about 20 degrees after pumping the purge bulb about 6 or 7 times and normal choke procedure I pulled it about a dozen...
-
BI just boxed up the cs400 for it's new owner. Costs anywhere from $18-$40 to ship a saw generally for me, usually $20-$30.
-
BI put this smashed 261C together after parts became more affordable; BGD and an extra muffler outlet. I'm pleased with it's power and rpm .
-
Bbrushwacker replied to the thread SOLD Husqvarna 550mk2.Sounds like a good deal.
-
Bbrushwacker reacted to HumBurner's post in the thread SOLD NIB550xp MKII w/ 20" bar and 33SPG chain with Like.
Thanks, Greg! I hadn't planned to sell some of these saws, but life keeps happening so, getting down to the essentials and no backups...