Basher's latest activity
-
Basher replied to the thread Issue with the other site.Quite easy, can you open the main page on AS, scroll to the very bottom and in the green bar at the bottom of the page click on, contact... -
So I have been doing some research. and I have an early SD111. This is an image of an early SD 111 brake assembly disassembled... I need...
-
Sorry guys been working turn arounds and projects - whelp I got my 501p back together last night finally and pretty sure I hung a ring...
-
I had to look it up and evidently it's a low emissions engine .That I once worked on an early 441 that also blew out plugs .If I recall...
-
The Helicoil Sav-A-Thread kit is M14x1.25 Mark
-
Experimented with the Stihl handle tubing on a pioneer handle and it worked pretty well to replace the old stuff. 19mm size tubing if...
-
As @jacob j. noted it is a Reed-Prentice/Craftsman 1200b. If you could see on the flywheel side of the case, it will have a badge that...
-
The boiler is installed, gas hooked up, and the building is now heated via radiant heat in the floor. Since so much time had passed...
-
Forget it. It is dealers only and it is good that not everyone messes with it.
-
Basher reacted to HusqvarnaDave's post in the thread Chain changing tension as it rotates with
Like.
I had this problem and it was the chinesium sprocket -
I downloaded an adblocker app. Or you can also pay a small gold member fee and get rid of them. It costs money to run the forum and...
-
Basher reacted to Mastermind's post in the thread Simplified---Adding A High Speed Circuit To A WG Carb with Like.
That's the simplest I can explain it. Questions?
-
Bringing this one back up after a few years of slumber….picked this up today…
-
if that’s the case .005 is pretty excessive. Usually the grooves are about .001– .002“ wider than what the ring is just for oil clearance
-
It seems a bit weird that it’s in a generic Oregon box, although it’s entirely possible that “Chainsawbars” simply assembled the loop...