Basher's latest activity
-
Most likely the overload protection kicking in. The oregon speed cut nano does well with these saws. I took the inspiration from our... -
Interior door & trim are being installed this week. The alarm was tied in to the current building this week so I am now covered...
-
It's starting to look like a saw - next up is to manufacture a kill switch wire, figure out a carburetor, finish up the recoil, and test...
-
The crank is in great shape so I was pretty happy about that. The saw had obviously been run but didn't have high hours, but the one...
-
I thought you guys might like to go through another HVA 394 build-em-up. A member here had a crisis moment a few weeks ago and was...
-
An attempt to fix leaky Pioneer oil and gas caps: On the gas cap, I removed the inner plastic vent valve holder, drilled the center...
-
Thanks! There are about 4 different common pitches depending on brand, and that varies between metric and imperial. Best to measure your...
-
My wife said "No!" to my request for a dog. So, I decided to immerse myself in 2 stroke smoke.
-
I got fed up fighting interference parts — seals, nozzles, pins, even rusty hardware — so I modified vise grips into a slide hammer for...
-
Basher replied to the thread Looking for Tillotson HL63.What other Mac`s came with a HL63 / My master manual only lists the HL63 as used on McCulloch saws but does not give the models, 11/16 "...
-
Honestly that’s not bad at all for heat if the bill was 150$ including everything else also. Put small one unit heat/ac in my bedroom...
-
I've been slacking on my progress reports. After several attempts the concrete floors are done, grind and seal up front and solid color...
-
P41 High Performance Build
-
Back on track 572 Not really artwork, it’s just one I did today
-
Basher reacted to lehman live edge slab's post in the thread Post up your ported cylinder Artwork with
Like.
Don’t worry I’m done, I’ll post some pictures of one I’m done and he can post whatever he likes. Was just trying to help like the whole...