B Royals's latest activity
-
BIt may a dealer-installed replacement cylinder - most of those had no markings and were not painted. Sometimes the dealers would stamp...
-
BB Royals replied to the thread Mcculloch 797, Super 797 thread.I've finished making blanking plates and rubber gaskets to perform a vacuum/pressure test. When I took the muffler off, I noticed the...
-
BDefinitely reclean your points even if they are new. New points i clean with 1200 grit sand paper then rub clean white paper through them.
-
BB Royals replied to the thread Mcculloch 797, Super 797 thread.It's alive! I pulled the flywheel off, and the timing had went retarded somehow. Re-set the timing and it fired right off. It sounds...
-
BI would start by pulling the flywheel, cleaning the points again, and rechecking the gap. The spec's call for .020" but I target 0.018...
-
BB Royals replied to the thread Mcculloch 797, Super 797 thread.I completely finished the saw today. I primed it up, and it fired off for about 5 seconds and died. I couldn't get it to restart after...
-
BYour arrangement seems correct and does match what the IPL shows. Make sure the key is fully seated in the crankshaft and that any...
-
BHere is a snapshot of the IPL for your reference, looks like you have the correct order, attached is also the full IPL for the saw...
-
BB Royals replied to the thread Mcculloch 797, Super 797 thread.Hello everyone. I have my saw all assembled except for the clutch assembly. I don't know if my stack-up is correct, and was hoping you...
-
-
BI don’t think it’ll be a problem having a larger fuel line, the only problem I’ve had with larger fuel line is it’s a little stiffer and...
-
BAwesome! Should make a great runner
-
BB Royals replied to the thread Mcculloch 797, Super 797 thread.I did as exactly as you discussed in an earlier post. I port matched the carburetor and gasket, as well as a touch of grinding on the...
-
BB Royals replied to the thread Mcculloch 797, Super 797 thread.I thought I'd check-in with a little progress update for everyone. Slowly but surely it is going back together. I used a bulkhead...
-
