59billy's latest activity
-
I have not had any of those come loose. (4 of em) By this I mean I have not had a 357-359 come loose without the support. -
59billy replied to the thread Not so pros 4 new and without politics or drama.Damn, man. Sometimes life is vicious. Stay strong--you will get through this.
-
59billy reacted to davidwyby's post in the thread Not so pros 4 new and without politics or drama with
Like.
How’s everyone doing? Been a rough winter. Both our dads passed, lots of traveling, mom Alzheimer’s/lawsuit. bathroom remodel, blah... -
Yeh, around 20% is my experience modding a 32cc clamshell. What my very ported 50cc saw cuts in 10 seconds, it cuts in 14.
-
Yes, I recommend this approach on those too.
-
Can this be used on 357 359 ? part number is 588775502
-
There are many different ways to do a muffler mod on these and results may vary depending on what other modifications you do along with...
-
placeholder
-
If you are just interested in getting a 350 back up and running well in a stock configuration, addressing the three issues above should...
-
The last big problem area for these saws is the mufflers rattling themselves loose. On some saws this led to exhaust gases burning a...
-
The next problem spot I want to address (only applies to saws with the cylinder riser) is the cylinder riser. On every single 350 I...
-
I'll bet. That was a good catch and fix with seals you had on hand from other bearings. I've only used one aftermarket set of bearings...
-
Haha yup I deleted the video of it running but it was crazy the crank would shift every time you hit the gas
-
Looks as if we were typing at the same time LOL.
-
@Shane¹ I too am looking for some clarification on your mod. Did you add another seal over the integral bearing/rubber coated cup with...