59billy's latest activity
-
Thanks for the add on the different thread types. Any of the AM risers I have gotten are based off the latest design with the M5... -
Great thread. I know of at least three bearing cups. The oldest had coursed threads on the cylinder and the crankcase screws. Then came...
-
Agree. A set of name brand bearings is dirt cheap.
-
Yep, I do that too!
-
One of my favorite 350 mods using a part that I stole from a 353 and mounted on a 350 with muff mounts that kept loosening up. I cut off...
-
So I can run my saw on bacon grease now?
-
bwaaaaaaaaaa!
-
59billy reacted to Kiwioilboiler's post in the thread Not so pros 4 new and without politics or drama with
Like.
Morena E Hoas. That's 113 and 79 or so I believe... -
As for builders on this forum, not sure if any would do a clamshell saw or not, but they are (in no particular order) @Red97 @tree...
-
59billy reacted to Tor R's post in the thread Not so pros 4 new and without politics or drama with Like.
Good morning slackers
-
The ones I've seen so far all have Gmail addresses that look legit. Apparently there are programs that can generate Gmail addresses. I...
-
We've already had a few AI bots try to take up residence here. They're likely programmed by a 13 year-old in Singapore.
-
As has been said, gains on a clamshell saw aren’t as high due to the inability to correct loose squish clearance and lower exhaust and...
-
I don't really have the time to start another project, so I'm actually looking for someone reputable. Spoke to one guy in Michigan...
-
59billy reacted to Stump Shot's post in the thread Not so pros 4 new and without politics or drama with Like.
Good morning. -17F 🌞