59billy's latest activity
-
59billy reacted to SawAddictedFarmer's post in the thread Not so pros 4 new and without politics or drama with
Like.
Good morning. -
I would be vigilant on a 026/260 for a seal to leak, laying the saw on its side allows the crank to shift and maybe snug up any loose...
-
I’ve found laying the saw on its side (clutch side down) stops the saw from dying compared to putting the saw down normally. Has anyone...
-
I personally would want to use a good new bearing with an aftermarket seal over a crunchy old oem bearing out of a part saw. If the...
-
Good callout on the AM parts thing and the slip fit of the bearings on the crank.
-
This feels like a good time to bring up: using aftermarket parts in this bottom end setup can really shake up a build. I've never...
-
351 is basically a 353 with a 44mm top end. Open transfers. Magnesium case. If we're bringing up Jonsered, it would be a 2149
-
If it was mentioned I missed it. Does a 351 case fit into this equation?
-
Perseverance is rewarding in its' own way.
-
59billy reacted to cuinrearview's post in the thread Not so pros 4 new and without politics or drama with Like.
Good morning
-
59billy reacted to cuinrearview's post in the thread Not so pros 4 new and without politics or drama with Like.
Mt. Pleasant- 21° dropping into the teens today. Headed to Marquette- 7/8° all day. Then to Gaylord, which is probably not that...
-
59billy reacted to Wonkydonkey's post in the thread Not so pros 4 new and without politics or drama with Like.
Good morning guys. It’s a sunny Saturday.. 5* - 10*C
-
Perfect timing for this thread to come up! Last cutting season my 350 developed an air leak. I shut it down and put on the shelf. I need...
-
I like your approach to this Greg. I know your a busier family man now. But, this site has needed some professional builder input for...
-
Bump, will sell powerhead only for $500 shipped.