59billy's latest activity
-
This is what it looks like when the vent is missing. This is on a saw with a primer (I can’t remember if all the 350’s have primers)... -
That is actually what I have been doing on a couple of saws in order to pick them up. The blips do work, and you can tell that it’s...
-
Just out of curiosity, I wonder if there is any difference if you blip the trigger a couple of times before picking it up, if it would...
-
I have a theory, because the carburetor is set so lean at idle, the throttle plate is therefor closed too tight/much to compensate for...
-
I would like this thread to be useful to folks down the road. That being said, I think this is a great addition. I'm sure other folks...
-
How about tank vents falling off? I worked on several earlier this year where the white vent fitting wouldn’t stay in the tank and I...
-
You can post up what you found. I do need to touch on tank vent modifications at some point in this thread for saws with the EPA vent...
-
There is definitely value in taking some time to modify the stock 350 for a low-buck rig. If you have run a good ported 346xp, you can...
-
Oh, I have a small pile of those, I think only one left with the stock dished piston. A couple of them are now 346s. Some of these are...
-
59billy reacted to Stump Shot's post in the thread Not so pros 4 new and without politics or drama with
Like.
I'll take it! Lol -
You know what I find funny? The guys most obsessed with oil have never wore out a saw or any other OPE in their lives. Sometimes they...
-
I've experienced the same thing but it's caused by vibration.. Putting the saw on the ground it vibrate the carb and would idle richer...
-
Good question. I've had the same experiences and don't have a fookin clue. I don't buy the flat spot in the manifold theory though.
-
Interesting question...and from the sounds of it, I'm not going to say anything that you don't already know/haven't tried. Letting a...
-
I have been dealing with several similar issues on a few different saws lately. The issue is definitely related to the carburetor on...