59billy's latest activity
-
The cylinder bolts on the 562xp are to be torqued to 8-10nm as per Husqvarna service manual … the case threads proper will give... -
He took some provisions with him 😉👍
-
You were supposed to live in New Mexico USA.
-
Got some Salsa dip yesterday, "Hot" & "Medium". Got some more "Hot" today AM.
-
Had a bit of a scare this morning. Was getting ready to use the blower to clean off the garage floor and saw something familiar - one...
-
59billy reacted to ray benson's post in the thread Not so pros 4 new and without politics or drama with
Like.
Yes, see the surgeon on Wednesday and probably 2 or 3 week wait for swelling to go down and make sure there is no infection. That's... -
59billy replied to the thread Not so pros 4 new and without politics or drama.Pro tip from a master mechanic: On saws with an outboard clutch, it is somewhat easier to install the sprocket if you haven't already...
-
I opened the factory exit and pulled the screen. I didn’t do this muffler, it was done when I got saw. I believe @Basher did it. Gonna...
-
The yard man has an infamous Kohler courage 22hp single, which I'll clean the carb on tomorrow and hopefully it will run good after...
-
Congrats!!
-
I'm officially 18.
-
59billy reacted to SawAddictedFarmer's post in the thread Not so pros 4 new and without politics or drama with Like.
Oh definitely!
-
026 is what he "needs" because I have leftover stuff and things.
-
The 261 with 72dl, 20” works great foe limbing. Good reach, good cut speed. Now, cutting 20”+ wood? Nope…too slow, imo. It will get...
-
I think a 3/8 72 driver bar sucks on 50cc saws, especially stock ones. That's more like 60cc.