59billy's latest activity
-
59billy reacted to jacktheripper's post in the thread Not so pros 4 new and without politics with
Like.
About to go test some stuff out today. Newly rebuilt 394xp and new bar and chain on the MOFO 034 Super. -
Walmart can be an interesting place....when we lived outside of Little Rock, I once observed a couple kids running around the store with...
-
Where we live it's expected that cars will yield, just walk across from parking to the entry. Don't bother looking. Home Depot...
-
59billy replied to the thread Aftermarket Rancher clutch covers.The later ones like the 460. I'm looking at it as an upgrade to the 345/346/353 series.
-
Are you talking about the 50,51,55 or one of the later model Ranchers?
-
I cut the band first, then the base. Combo deal?
-
Any chance it happened when you were cutting the band? It’s much more likely that the bolts pulled the corners up, which could...
-
so making to bottom thinner made it tweek a little where the transfer ports are is what your thinking is. huh that is interesting
-
The 350 and 353 closed port 45 mm cylinders are indentical. The only difference is the dished piston in the 350 vs the flat top piston...
-
When I tighten those muff bolts I check them again after first startup & shutdown, many times they will tighten a little more, then I...
-
I think they were only supposed to go to 12,500 to begin with. Funny thing is I was at a service school where they told us to turn them...
-
I was told years ago at a husqvarna service school that the vibrations were caused by engine over speeding due to carb being set to...
-
I like my 353 well enough for small firewood duty. Ported with a welded pop up it runs pretty good. 346 ported is an animal though.
-
I'd still prefer the 44.3mm top. I just went pretty far with an OEM 350 jug, maybe I'll like that better, but the NE top is fast but...
-
Howdy all! It's been forever since I've been on here... Anyway, I've got torched 346XP NE that has a decent scratch above the exhaust...