Fruecrue
certified hand catcher
- Local time
- 10:57 AM
- User ID
- 2417
- Joined
- Jan 4, 2017
- Messages
- 4,391
- Reaction score
- 21,690
- Location
- Alden NY
Dolmar 7900/ 7910 mutt.
I acquired the carcass a while back and stole from it for my build off saws.
It’s been here collecting dust for a while even after acquiring parts and finishing it.
I can’t remember what all is new/ used etc.
Runs, idles, oils, cuts.
7910 bottom end that was either rebuilt with new bearings or deemed serviceable at the time. New OEM seals at a minimum.
7900 used P+C in good condition. May have deleted gasket ?
I remember testing compression and reading about 185.
Has been converted to unlimited husky coil.
Muffler has a crude mod and a dent.
HD filter set up, cover had a crack that I plastic welded.
One recoil screw was stripped and poorly repaired with a helicoil but seems to work fine, two OEM recoil screws were missing and AM screws substituted.
$425 PHO plus shipping.
I acquired the carcass a while back and stole from it for my build off saws.
It’s been here collecting dust for a while even after acquiring parts and finishing it.
I can’t remember what all is new/ used etc.
Runs, idles, oils, cuts.
7910 bottom end that was either rebuilt with new bearings or deemed serviceable at the time. New OEM seals at a minimum.
7900 used P+C in good condition. May have deleted gasket ?
I remember testing compression and reading about 185.
Has been converted to unlimited husky coil.
Muffler has a crude mod and a dent.
HD filter set up, cover had a crack that I plastic welded.
One recoil screw was stripped and poorly repaired with a helicoil but seems to work fine, two OEM recoil screws were missing and AM screws substituted.
$425 PHO plus shipping.