Cylinder base milling - services needed

[benjpi]

I'm looking for someone who's got time to cut an aftermarket cylinder for a Husqvarna 55. The current squish without a base gasket is 0.050", and I measured a compressed base gasket at 0.010" (I checked the squish with no base gasket, but I'd like to use one so I don't have to cut an impulse passage into the case. The compressed gasket thickness was the old one.).

I'd like to get the cylinder base cut 0.040" - 0.045", to get 0.020" squish. Does anyone have time to fit that in their build schedule?

ben

 

[srcarr52]

Sure. I’ll send you a pm with my address.