Search results

SOLD - I made this 6061 Billet cylinder Mandrel years ago and never used it. I was planning to set it up to turn the bases of cylinders using this as a mandrel. I remember it having only about .0005-.001 max runout on my Mitutoyo tattle tale when I made it. SOLD

SOLD Greetings all, I have had this saw for over 6 years. In that time, I have slowly accumulated a brand New OEM Husqvarna NE cylinder kit, a new Total Super Pro bar, and a new Stihl 23RS Chain for it. I even have a two idiots logging kickstand felling spike that is brand new and included...

Hello Gang, I have decided to part with this super-nice McCulloch Pro Mac 800 that is an all original, low-hours saw that runs perfect, and has awesome compression. I am replacing the fuel line with an OEM McCulloch fuel line and Husqvarna fuel filter this week, as well as a fresh rebuild on...

Hello All, I have a very nice used OEM fuel tank for an MS660 Stihl chainsaw. I don't see any cracks, nicks, or ugly spots on this one! It looks really good. This does have the screw in cap assembly, not the flippy-cap, so you know it is for the early 660. I am asking $120 shipped to...

Hey Gang! So, I am finally about to get to my J’red CS2149 conversion to a 346 Xp NE OEM piston and cylinder, and I was trying to figure out the best muffler and carb combination for it. I am planning on a base gasket delete, but I just cannot afford any port work and I don’t have the tools or...

Hello Gang, I know these are considered pretty cool/mean old saws by the Homelite lovers. This saw has a scored piston but is otherwise complete. I would like to get $70 shipped to Con. USA. Thanks!

This Echo saw runs awesome and sounds great. It does has a cracked recoil cover on the front lower corner. It does have three bolts to retain it so it will work fine for use. If you are going to use it much, it might need a new fuel line, as the original is old, but not leaking. I would...

I have approximately 25 of these. They say .315, but .325 chain wraps around them just fine. If someone will give $50 shipped to Con. USA, they can have all of these NOS spur sprockets.

Hello all, I measured from center of rivet head to center of the other rivet head and I believe I came up with .5130, so 5/8 chain, correct? It is currently wrapped in three levels on an old metal belden wire roller, I am sure the cardboard spool collapsed under the weight. It is dusty and...

I have an almost complete roll of new old stock Oregon chain, made in the USA. This is the model 72SG 3/8 chain with the 72 driver that is .050. Also comes with a bunch of ties and pre-sets as pictured. No rust on the chain at all, it looks perfect. I am thinking $150 + shipping at cost...

Hello Gang, I have a very nice Stihl 041 Farm Boss here that I need to sell to fund other projects, like always..... I wanted to present this here on OPE in case it was missed because it was on another site as well, but I feel like it might have more interest here. I took this in on a...

Hello All, I have some brand new 3/8 Windsor Bars, made in the USA. These are model number HS-388-60 J58T - .058 guage These are 16 inch bars. how about $35 each shipped to Continental USA?