Search results

So....Brother-in-law brings me this nasty looking little CS-340 Echo saw. Tells me it hasn't been started for years.....and last time he tried to cut with it the chain had become very dull....so dull it would not cut at all. The saw looked to be covered with mold, pump bulb rubber was missing...

Stumbled on to this today while nosing through CL ads. Just thought somebody might be interested. https://kokomo.craigslist.org/grd/d/elwood-stihl-chainsaw/6871686817.html

My Dad has an MS170. He's 80 years old and has bad shoulders. He struggles to start any of his saws...even installed a decomp valve on his 026. Well now it hurts him to pull the rope on his MS170. What would it take, parts wise, to put an easy start recoil on his 170?

Hey folks. I need a piston and cylinder for a Poulan 2775 Type 3 (at the end of the serial number there is a "dash" number....needs to read "- 3") If you have a good used P/C you would like to sell please contact me. Thanks!

I have an 041AV with intermittent spark. I disconnected and pulled the coil. I checked continuity from the core to the low voltage white wire (the one that attaches to the condenser along with the points and kill-switch wires). I have continuity on this wire to the core. Next I tested...

Edited to simplify: I need to time this ignition. So should I set the points so they open when the flywheel mark is aligned with the mark on the case? Thanks

The subject saw has arrived at my bench. Owner discovered it had no spark. He replaced the condenser and said it still won't run. So that's how I received it. Gave it a spin and it does have spark, but not sure how strong a spark it has. Is there a good way to test the condition of a...

Okay so they finally started selling premium e-free gasoline here local. Mixed up a couple of gallons filled my MS260. Started cutting....running rich. Hmmm. Started leaning it out with the H needle. Took a complete 1/2 turn CW to get it tuned proper again. I guess that ethanol really does...

Hello folks! Need some expert opinions. I just finished doing a re-build on an MS310. New piston, cylinder, crank bearings, seals, and muffler. Disassembled and cleaned the carb while I was at it. So, put it together, poured some premium premix in the fuel tank and some chain oil in the oil...

Hey folks! Have any of you all tried out one of these Timberline brand Chinese bars? If so, what is your impression? Thanks!