Search results

Looking for an 066/660. I interested in a good running one and/or a project one. Looking to use this saw so I don’t need one museum quality. Just not totally beat. Sent from my iPhone using Tapatalk

Helping my cousin build his 034. He needs a recoil assembly with 4mm bolts. Would possibly interested in a whole parts saw. Sent from my iPhone using Tapatalk

Looking for a good 064 fuel tank that’s in an overall good condition cosmetically. Sent from my iPhone using Tapatalk

I’m am possibly looking for a good 034 crankcase with good bearings and crank. I need one with the 4mm starter screws. I have an 034 that needs crank bearings. I have all of the other parts to complete the saw. Just not sure if I have to time to split cases right now. Sent from my iPhone...

I need a good OEM brake handle. Hoping for it to be decent cosmetically. Sent from my iPhone using Tapatalk

Looking for a good running 066/MS660. Not looking for a basket case. All OEM please.

I’m looking to sell this 066 Flat Top Red Light. I bought this saw as a runner from a member on the other site. I was told that the seller received the saw with a bad top end. He said that the saw was run too lean as a carb issue. He replaced or cleaned up the OEM cylinder and put a new meteor...

Looking for a good 034/034 super cylinder, muffler and recoil cover and assembly. Sent from my iPhone using Tapatalk

Looking for a good muffler, chain brake parts, chain brake cover and filter cover,

I bought a used 036 a few years ago. Never really ran well. I also never dug into it until today. I found the cylinder to be lightly scored on the exhaust side. I also found the cylinder lightly scored. I don’t feel and deep scratches in the cylinder. The top of the piston has a lot of...

I am in the market for a clean 036/036 pro or MS360/361.

I am looking for a good used OEM cylinder or reasonably priced OEM kit for a MS361.

Looking for a ‘big saw’ project. Not looking for a completely raped saw. Just something to tinker with.

I'm rebuilding another 026. I've replaced the seals. I did a vacuum leak test and it takes two minutes, 50 seconds for the the gauge to go from 10 down to 5. According to the service manual, if it holds vacuum for 20 seconds you are good? I assume my test is acceptable? I could not find an...

I am looking for a good 44.7mm OEM Cylinder.