If it is an older oregon bench grinder or a copycat. On the backside of the chain clamping rails, there is usually a screw that pushes the rails forward. That is the adjustment so it will grind evenly for left and right teeth. if that is what you're saying as "evenly
I would just use a used OEM coil. Lots on eBay. I use mostly NGK plugs. Check you gap between your IM and your flywheel. If your bearings are going on the flywheel side you could have problems. Also make sure your flywheel nut is tight and properly indexed to the key way. As that determines timing.
You might try to ask this question in chainsaws page. There is a little more traffic over there. Maybe someone can move it. You have it in the repair shop. I don’t have a lot of knowledge of these saws.
A little off subject what happened to the biodiesel movement? I know gas prices went down but for a while just about every restaurant had someone interested in their used fryer oil. Seemed like there was quite a bit of interest in making your own biodiesel. Is there a price point that it’s not...
The 575, most that I have seen have the blue rev limited coil and a normal carb. As stated I believe it is the 576 that is auto tune. They have a grey coil and different carb. Some 576 are not auto tune. Other than that and how the transfers blend into the case they are very similar.
The 575...
That harvest king is about as cheap of bar oil I have found. You could try cutting it with something. I don’t like the smell of new gear oil and used stuff is even worse. When oil prices got high in 2008 there was bar oil that was refined used oil. It wasn’t great it was cheaper.
Some bulk oil...
6-10A, either a 1-70 or 1-71 and a 250. I was thinking 20:1 would be a little much.
Aside from priming in the spark plug or into the carb anyone ever make a reserve fuel tank. I have seen it done on cars and small engines but not saws.
A couple tanks have some pretty heavy varnish And the the...
Question. On the 3 series and old 5, 575,576 a blue coil is limited. I have a 266 that has a blue 2 piece ignition. A coil and igniter. Not sure I don’t have one on another 2 series saw also. Or that one is blue and one is black on the same saw. Are these saws rev limited? Or was this just that...
- Outer smooth felling dog
Not sure if you found any there are quite a few on eBay. One guys has the set and another has a whole pile of the outlers. They are listed under jonsered.
I have a couple older Mcculloch chainsaws. The model numbers plates and stickers are gone. Is there anyway based on part numbers or something else to tell what saws they are? I suppose a couple of pictures would go along way. Thanks
I mostly leave mine in the summer position. It does seem to make some difference in colder weather. If you are cutting and the saw sits off. Not having to choke it to start it. At least on the stihls I have. I think on some husky’s there was a little pice of plastic that slid open and closed.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.