Recent content by t4driller

Nla, sold.

Looks mint.. definitely a keeper.

All the 359s or 7s i got had 199s or 175s on them. Im not sure if tget came on tge saws actually or if they were just a replacement because of tge 199 problems. Most of tge 199s i have are junk and couldn't be fixed. So i just keep el42s in stock.

I buy new carbs off ebay. Usually 30 bucks shipped. Paid 25 shippes for a couple. All they had. I havent seen any on used saws. At my dealer tget are listed as 359 carb

Same reason i switched to the el42s. Dont have to mess with them. Piece of mind.

Not much. Like 5 degrees. Sometimes a hair more. It does help with throttle response though. I tske a swipe or 2 with file and check it. Keys are cast in so you csnt just grab another key like on stihls.

Took the words right outta my mouth. Lol. [emoji38]

Like Onan said, 359 intake tract is an easy upgrade. Not very expensive. For the muffler just add a second port with deflector on pto side. Just gotta make sure to put it in correct spot so it dont hit case or burn top cover. Does your muffler have baffles in it or just a hollow can? With...

Nice bike

Thing was alot of fun. Had to put a Muncie 4 speed behind it. 5 speed wouldn't hold up long.. motor is on stand in garage.. Ok. Bout ready to turn in. U?

All i gots is a hood left off mine..[emoji53] 383 stroker with high rise intake wouldnt fit under stock hood.. [emoji12]

This is the new post a pic of your mullet ride thread... I could probably even throw in a free cassett tape of ac dc, metallica, or somethin to buyer.

I had an 86z28.. no t tops.

Best answer

Lmao... dustin would look good eith a mullet..