Brand new saw... Bought two from a friend that never even started them..
So i thought i would pass the deal on to some one else that might actually use it instead of it collecting dust.. I have started it to warm up and tune other wise has never seen wood
PHO 800$ OBO
I have sold my bigger stock saws and have been looking for a good ported saw for a while. Mostly looking for 362/441/460 ect... PM me and let me know what you have
No its electrical rosin core solder. I checked it probobly 10 times to make sure because i thought it was wrong to lol. But i got .040/.042 every time.. I took your word on it mastermind and cut up a beer can am going to check it now
Top end was rebuilt last april and has about 10 tanks ran through It. Cuts great and runs great. Has muffler mod but other then that all oem parts were used.
550$ shipped
I got 0.040 / 0.042 with the gasket. Going to try and do alittle grinding tonight and see how it turns out... Any ideas on porting and can i do anything with the stratos
Ok but if i still want to use a gasket do i have the jug milled down or the base of the case were the cylinder sits i dont really want to use a sealent
Im going to try a base gasket delete on my 261cm.... wondering if its going to mess with the m-tronic system and also what some other guys may use for a seal or gasket material?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.