Came across some cherry today....

[quietfly]

 

[Mastermind]

Good looking stuff Chris.

 

[quietfly]

Good looking stuff Chris.

thanks, but did you see my best work, over in the off topic area?

 

[Terry Hennessy]

I have an Alaskan mill , the issue was my rental saw limiting my milling width.....

You can remove the bar-tip hardware, and extend the usable portion of the bar. However, the 12-inch is max for (most) home shop planers anyway

 

[quietfly]

You can remove the bar-tip hardware, and extend the usable portion of the bar. However, the 12-inch is max for (most) home shop planers anyway

I built a router planer jig so i dont have that restriction on width, right now the issues is just waiting for the moisture content to get down to a usable level. It's sitting at 20 percent. Im planning on building a solar kiln in the next few weeks, once i get it to about 12 percent, ill start the real work.....