Stihl bar on 562xp

[Spladle160]

Anyone run a Stihl bar on a 562xp? I keep running into obnoxious snags. first the 562xp studs are closer than most 9mm Huskys and I need a different adapter. Now the stud for the bar adjuster is larger than the holes in the bars. I gues I could drill the holes but would rather file the studs. Any thoughts? Am I missing something?

 

[Spladle160]

Flat file fixed it in a few minutes. In case anyone else runs into this question my solution was cannon bar adapter CBW 20020 and pulling the bar adjuster stud and filing it down to a 6mm diameter. All done.