SELLING Stihl 076/075/051 1111 NOS parts

[nv656]

Clearing out some extra NOS parts I will mot be using. Reach out for any parts you are looking for
NOS fuel tank asking 120$
NOS muffler $80
NOS Lower brace 75$

 

[hacskaroly]

Do you have a throttle linkage 1111 182 1500, not the shorter 1111 182 1501? The 1501 is about 1.5 inches too short and works on the newer 075/076s. The 1500 linkage works on the older 075/076s.

 

[nv656]

Do you have a throttle linkage 1111 182 1500, not the shorter 1111 182 1501? The 1501 is about 1.5 inches too short and works on the newer 075/076s. The 1500 linkage works on the older 075/076s.

Did not realize there was 2 let me look through my tote. Do you have a total measurement or was it based off what carbs were used?

 

[hacskaroly]

Did not realize there was 2 let me look through my tote. Do you have a total measurement or was it based off what carbs were used?

I will have to make a measurement when I get home, yeah, was surprised too to find out that there were two different ones. There was a discussion on AS about this, that is how I found out the part numbers.

 

[hacskaroly]

Here is a pic of the TR 1501.

 

[Rusty Husky]

I will buy the muffler. Do you have pictures of it and the lower brace?

 

[hacskaroly]

Here is a pic of the TR 1500


Here is the TR 1501

 

[nv656]

I will buy the muffler. Do you have pictures of it and the lower brace?

I’ll get you some pictures after work of those

 

[nv656]

I will buy the muffler. Do you have pictures of it and the lower brace?

Muffler and lower handle

 

[nv656]

Here is a pic of the TR 1500
View attachment 458981

Here is the TR 1501
View attachment 458982

No luck on any linkages, it’s a good thing to not there was 2 sizes so thank you for the info

 

[nv656]

More^

 

[hacskaroly]

No luck on any linkages, it’s a good thing to not there was 2 sizes so thank you for the info

Bummer, but yeah, I was fooled out of $8.00 once...lol. I have made a few from bending tire spokes, but this is a last resort and it is for someone else's saw. Once I get them hardened, I might give him a spare just in case he might need it in the future. I need to find a better way/tool/jig for bending wire more consistently. I have made several and no two are like each other, close, but not as consistent as I would like. Again, I appreciate your checking what you have!

 

[SimonHS]

Bummer, but yeah, I was fooled out of $8.00 once...lol. I have made a few from bending tire spokes, but this is a last resort and it is for someone else's saw. Once I get them hardened, I might give him a spare just in case he might need it in the future. I need to find a better way/tool/jig for bending wire more consistently. I have made several and no two are like each other, close, but not as consistent as I would like. Again, I appreciate your checking what you have!

Piano wire of the same diameter as the original will work well. You can get these wire bending jigs cheap on Amazon. You should be able to bend up a long throttle linkage easily with a jig and a pair of needle nose pliers.