Vancouver timber
Well-Known OPE Member
Got this one or trade for a winch it had just had new bottom and top end bearings put in aswell as a set of rings and an oem gasket kit it I have the bill for the work done if you want to see it wasn’t cheap. Guy got the saw back it started once at the shop and never again I ended up throwing a new coil on it cleaned it up rebuilt the carb new fuel line fuel filter spark plug put a fw side seal in it (why the shop left a bunk seal idk) I also because I had then put 3 new clutch springs in and a new rim hub sprocket kit all parts used in this build were oem including the bearings it’s a nice saw runs very strong Starts good isles normal snappy bottom end response heated h bars and a carb are always nice as were comming up on that season. New 18” husqvarna brand bar w/ new 33rsc72e or a used but ground 28” Oregon bar with a oregon or husqvarna new chain aswell. New sprocket cover too guys oem aswell
Selling to fund parts for my 064 build it’s a nice saw!!
Selling to fund parts for my 064 build it’s a nice saw!!
Last edited:
