Jimmy in NC
Pinnacle OPE Member
- Local time
- 5:55 PM
- User ID
- 57
- Joined
- Dec 23, 2015
- Messages
- 1,994
- Reaction score
- 8,012
- Location
- North Carolina
Fully rebuilt MS440. Fresh powdered cases. New Walbro HD50 carb, AM plastics and tank but I can include the OEM plastics if you want them. They are there and complete but old. Scarr ported 044 OEM jug and new OEM piston at build time. There was a pair of tiny streaks on the piston that were two little spots of transfer left during initial build. I cleaned the cylinder and the piston you cannot feel the marks... simply polish streaks. Just laying it out there. Saw hits with out a base gasket so it has a base gasket but it's a full port and squish... base gasket measured .022". I am guessing squish at .019 or so. Runs real strong....real strong. Tuned at 14,200 it holds 12,100 in dead dry red oak with a hand filled chain. Questions...just ask. I dunno where to start but let's try this.
$675 gets saw PHO, OEM plastics, unopened MaxFlow filter kit, and I will split shipping in the Contitental US. Serious offers...ask them. Not looking for trades right now.
If you need a bar... we can work on that too. 20", 25", 32", or 36".
$675 gets saw PHO, OEM plastics, unopened MaxFlow filter kit, and I will split shipping in the Contitental US. Serious offers...ask them. Not looking for trades right now.
If you need a bar... we can work on that too. 20", 25", 32", or 36".