I just picked up this saw and I am moving it on to fund a lathe purchase.
I know very little about this specific model I will list the good and bad to the best of my knowledge.
Starts, restarts and revs out great!
just under 150 psi and the bore looks great through the plug hole. very little carbon on top of the piston. I don't think it has seen much use.
oils good and I see no cracks, holes or structural damage.
nothing is bent or out of place.
this was a ride in the back of the truck saw.
the top covers are faded, the air filter cover is cracked and the brake handle is broke on one side but the brake still works.
it looks like there is a time sert in the sparkplug hole
arctic switch it self is missing
one 8mm nut on the bottom of the muffler is rounded over enough it is not coming out easily.
may need a crank seal or carb boot. idle changes when its rolled on its side.
Looks like it was a $900ish saw new. I'd like $350 plus ship pho
I know very little about this specific model I will list the good and bad to the best of my knowledge.
Starts, restarts and revs out great!
just under 150 psi and the bore looks great through the plug hole. very little carbon on top of the piston. I don't think it has seen much use.
oils good and I see no cracks, holes or structural damage.
nothing is bent or out of place.
this was a ride in the back of the truck saw.
the top covers are faded, the air filter cover is cracked and the brake handle is broke on one side but the brake still works.
it looks like there is a time sert in the sparkplug hole
arctic switch it self is missing
one 8mm nut on the bottom of the muffler is rounded over enough it is not coming out easily.
may need a crank seal or carb boot. idle changes when its rolled on its side.
Looks like it was a $900ish saw new. I'd like $350 plus ship pho
